I made this CR 2430 button cell battery holder to fit inside my battery caddy in the D Battery slots

• Fits 9 CR2430 coin cell batteries
• Push the battery all the way in and it friction locks in
• Easily remove any battery
• No batteries will fall out if you tip it or roll it around

Fits in a D battery slot, I made for the battery daddy that costco or amazon sells (I assume it will fit any D battery holder, if not I can make it a smaller in diameter)

Let me know if you have any suggestions for edits on this battery dispenser

Print it laying down flat, it prints best that way, you can print it standing up but its messy.

Print laying down with tiny bit of normal supports on the pull tab