Terro Liquid ant bait holder by bampoo

bampoo

Household>Garden

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

59 min

1 plate

4.5(2)

0.24mm layer, 2 walls, 15% infill

Designer

48 min

1 plate

Open in Bambu Studio

Boost

Released

Description

This is a simple container to hold the Terro® T300 Liquid Ant Baits traps. You could also just put ant dust in it. The lid has an overlap to help it prevent water from entering through the top making it ideal for indoor or outdoor use.

I have tested this outside through rainy days and it has not accumulated any water inside. If it filled with water the ants would probably not go in or the ant bait would be washed out.

ant bait terro liquid ant baits

terro t300 liquid ant baits poison

Comment & Rating (4)

@user_4196189828

Print Profile

0.2mm layer, 2 walls, 15% infill

tolerances were a bit too tight and the clips broke immediately but otherwise works!

The designer has replied

@bampoo

I've made about 10 of these with 3 separate spools and none have broken so my guess is either your printer calibration and/or filament. I'm curious if you did a re-calibration and used a different spool of filament whether you'd get the same results. Can also try 0.24mm height. Anyways, I will make a version 2 with slightly beefier clips. Should be up in a couple days. Thanks for your feedback.

(Edited)