Gridfinity - Arduino Nano v3.0 Storage Bin by Toby

Toby

Tools>Organizers

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 3 walls, 13% infill

Designer

57 min

1 plate

5.0(1)

Open in Bambu Studio

Boost

Released

Description

Do you find yourself digging through piles of electronics, PCBs, and various bits and pieces in your drawers or storage containers? Let's put an end to the clutter with Gridfinity!

Check out my newest addition: A 1x1x6 Gridfinity Ardunio Nano v3.0 storage bin. The storage container can fit up to five Nanos vertically. While being relatively tight, you can still easily add or remove single Nanos without effort.

The model supports friction-mounted 6x2mm magnets.

My preferred printer settings:

Material: Bambu PLA (Tough) on a Textured PEI Plate
Presets: 0.20mm Standard
Walls: 3
Infill: 13% Gyroid pattern

You can tweak the wall thickness and infill to use less material, but these settings gave me the most even-looking print.

Please share any thoughts or suggestions on this model. I always appreciate your feedback!

My other designs:

Please take a look at my other designs, too. If you can't find what you need, just let me know. I'm here to help fill in the gaps in the collection for you.

Happy Printing!

Gridfinity by Zack Freedman: https://www.youtube.com/watch?v=ra_9zU-mnl8

Comment & Rating (9)

@Freebird

Boosted

I love your storageboxes and have the esp32 box already in use. I have though a problem with the Arduino nanobox. most of my nanoboards have headerpins and they don't fit in these boxes. For I am not very good in CAD I really hope you will find time to make a box in which my Nano's will fit. I'd be mighty grateful

The designer has replied

@toby_nz

Hey @Freebird , happy to hear that you like my boxes. 🤗 If you send me a message with the dimensions of your board, I would be happy to provide a version for you. However, it might take a few days...

@Freebird

Boosted

Replying to @toby_nz :

Thanks a lot. No need to hurry. I will send you photographs and measurement.

@Freebird

Boosted

Replying to @toby_nz :

Hi Toby, This is what I found in the official datasheet of the Arduino Nano. Perhaps it will be helpful. Kind regards, Freebird

@curtchose

Hey! Can you provide the one on the picture in the front, for the 10 nanos without headers? It's not in your files but i'd like to print it :)

The designer has replied

@toby_nz

Hey! Yes, of course. Thank you for the hint, I didn't notice that I missed to upload this model. I will publish it tomorrow and provide an update with the corresponding link in this thread. 👍🏻

@toby_nz

Hi @curtchose , I just uploaded the 10x storage bin for the Pro Micros. Unfortunately, I didn't realise that the bin wasn't for Nanos. The problem is that at least my Nanos are minimally wider than the Pro Micros, which doesn't allow putting two next to each other. If you like, give it a try and let me know if they also fit for the Nanos. Feel free to drop me a PM for further discussion.