Cute Darth Vader - Star Wars Pot Plant
Remixed by
Cute Darth Vader - Star Wars Pot Plant
Remixed by
Boost
19
32
1
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
4.4 h
1 plate
Open in Bambu Studio
Boost
19
32
1
1
41
9
Released
Description
Any feedback would be greatly appreciated.
Could be use as a planter, pen holder, etc
Nozzle:
0.4-0.8mm
Layer:
0.24-0.4 (Recommended)
Supports needed (paint-on supports)
Scale it as you like :)
Comment & Rating (1)
All
printed this on my PS1 for a gift. print was clean but has a lot of supports. that was fine, but some of them underneath were a bit difficult to discern and hard to get to get to. once I worked out what to remove and what to leave, it looked great.
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld