Hello everyone,

we designed an abstract and light sculpture that you can use as a decorational object for your house/apartment.

The sculpture is depicting a woman with a hat.

The foot/stand is included and with it the sculpture is perfectly balanced.

Print settings:

• I used the smooth PEI plate for better adherence and a clean surface --> no brim is needed.
• If you prefer the textured PEI Plate, make sure it's very clean to get it to adhere to the plate properly.
• It can be printed with a brim to incrase adherence, but oftentimes, it leaves small residues/different colours where you remove it.
  So i personally recommend not using a brim if the plate is sticky enough.
• Layer hight 0,2mm is more than fine enough since the sculpture is only 2,6mm thick in both directions.
  

If you like the style of this sculpture, check out our similar models:

Woman with Flower Hair: https://makerworld.com/en/models/407266#profileId-309333

Woman with Hat: https://makerworld.com/en/models/407255#profileId-309324

Flamingo from Picasso: https://makerworld.com/en/models/407288#profileId-309349

Freedom Dove from Picasso: https://makerworld.com/en/models/407270#profileId-309340

Abstract Mouth: https://makerworld.com/en/models/407349#profileId-309387

Bull from Picasso: