水果清洗篮，双层设计，上层沥水下层储水。沥水部件顶部有一个帽檐以便与下层储水部件配合，为了减少支撑，建模时添加了支撑牺牲，在打印完成后可以轻易拆除，只在侧面留有一圈壁的痕迹，不影响整体美观性。进行切片时在顶部特定高度可以看到一圈悬空墙，实际下方支撑与它有0.15mm空隙（100%大小时），如下：

Fruit washing basket, double-layer design, upper drain and lower water storage. The top of the drain part has a brim to cooperate with the lower water storage part. In order to reduce the support, the support sacrifice is added during modeling. It can be easily removed after printing is completed. Only a circle of wall marks are left on the side, which does not affect the overall aesthetics. When slicing, a circle of suspended wall can be seen at a specific height at the top. The actual lower support has a 0.15mm gap with it (100% large ). The slicing is as follows:

支撑牺牲 support sacrifice

如果使用传统支撑需要356g PLA，而我的这个支撑牺牲方案只需要239g，节约约30%。If using traditional support requires 356g PLA, my support sacrifice requires only 239g, saving about 30%.

支撑牺牲拆除后效果  Surface effect after removing  Support sacrifice

原始比例大小  Original scale size