X1C P1S Door Edge Seal 1 Piece [TPU]
Copyright Claim
X1C P1S Door Edge Seal 1 Piece [TPU]
Boost
15
32
5
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1 h
1 plate
Open in Bambu Studio
Boost
15
32
5
1
23
21
Released
Description
In the quest to get my chamber temps up as high as possible without a blanket, I noticed there is a gap on the back side of the door by the hinge. So I designed this one piece snap in place seal to be used when you are printing Nylon, ASA, PC, ABS, Etc.. Also Helps with keeping the smells in. I recommend you make sure your build plate is installed perfectly because this print uses the entire area. Also save my TPU print profile as I have found this to give the best TPU prints. PLEASE NOTE - THIS IS NOT DESIGNED TO STAY ON THE DOOR AT ALL TIMES, ONLY WHILE IN USE!
Comment & Rating (5)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Good design with a tight fit. It comes in handy when printing ABS and ASA. The only issue I have with it is that it cannot be kept on the door as it falls off when it is opened, so it is good for the print duration, but not for storage. This is not the fault of the design, but rather the machine.
(Edited)
The designer has replied
0
Reply
I’ll add a note to the original description. I didn’t design it to be left on the door, just on while in use. Glad you like it otherwise, Thanks!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Works perfectly to minimise door leakage when required for anything like ABS, ASA and TPU that may have unsafe fumes when printing.
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
very tough fit, pops off here and there
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld