Bambu Lab A1 mini Tool Box

Bambu Lab A1 mini Tool Box

Boost
110
217
32

Print Profile(1)

All
A1 mini
P1S
P1P
X1
X1 Carbon
X1E
A1

0.16mm layer, 2 walls, 15% infill
0.16mm layer, 2 walls, 15% infill
Designer
5.7 h
2 plates
4.6(26)

Boost
110
217
32
7
283
172
Released

Description

A storage box for the Bambu Lab A1 mini tool set. The cover and tray must be printed individually and then pressed together.

The cover closes perfectly with two 6x2mm magnets.


In this version, I have swapped the Bambu Lab logo on the front with the lettering.

 

Have fun printing!

 

Don't Panic, just print it ;)

Comment & Rating (32)

Please fill in your opinion
(0/5000)

poor design as far as trying to fit the bambu lubricant oil, doesnt fit or allow lid to close
The designer has replied
1
Reply
Really sorry that you're having trouble with the printing. As you can see from my pictures, the tubes fit perfectly in the box. In your case, you probably have different tubes than I do. I assume that Bambu Lab sends different sized tubes with the printers and does not have a one size fits all solution. I hope you still had fun printing! Thank you for your comment. 🙏🏼
0
Reply
Love this Toolbox! Oddly, placing the lubricant tube inside didn't allow my lid to close, but otherwise it works really great with the 6x2mm magnets.
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Printed good
(Edited)
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
(Edited)
Other Issues:The space for the lubricant is smaller than the lubricant. The balls to couple the lid printed badly and was hard to couple it and the lid won't close because, again the space for the lubricant had to be more profound (maybe that issue is covered if you install the magnets, cuz i didn't).
The designer has replied
1
Reply
Really sorry that you're having trouble with the printing. Without images, unfortunately, I can't offer real help. To connect the lid to the box, the lid must be pressed onto the box with a lot of force. The cut-out on the box are designed so that the connection point on the lid fits perfectly. The lid should already be perfectly flush with the box without magnets. The magnets only serve to keep the box closed during transportation. I wish I could help you more! Hope you can solve the issue. Thank you for your comment and rating. 🙏🏼
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Fits everything you need
1
Reply
Boosted
nice
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
nice box
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
printed well but the lid, when opens is slightly too close to hinge piece on box. could be warping or slight model adjustment needed
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
I had some warping issues with the lid Over all nice box.
1
Reply