Tusken Raider Toothpick Dispenser
Remixed by
Copyright Claim
Tusken Raider Toothpick Dispenser
Remixed by
Boost
17
34
6
GIF
Print Profile(3)
0.2mm layer, 2 walls, 15% infill, inner brim
Designer
1.9 h
1 plate
4 color raider, 0.2mm layer, 2 walls, 15% infill
Designer
2.8 h
2 plates
0.2mm layer, 2 walls, 15% infill
3.6 h
3 plates
Boost
17
34
6
1
26
16
Released
Description
I saw shusy's design a while ago and had the idea for this. I used Ctrl-P's remix for the base.
I prefer it without the lid so you can see more awesome Tusken detail. I also considered gluing a spring in there to make it more of a surprise, but decided against it because it would require two-handed operation.
I printed the slide upside down with the funnel pointing up and had warping issues. I suggest using a brim on the slide. The raider prints flat on his back. You can do the color change on the raider around 2mm. I colored in the details with Sharpie markers.
I've included Ctrl-P's parts for convenience and renamed them for clarity.
This should work for toothpicks up to 6.5cm in length.
Filament:
Inland PLA+ Brown, Bone
Comment & Rating (6)
All
Print Profile
0.2mm layer, 2 walls, 15% infill, inner brim
The designer has replied
1
Reply
@ArchedAngleCrea Looks good! Thanks for sharing
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, inner brim
klappt nicht mit jeden Zahnstocher
The designer has replied
1
Reply
@u.boa2 Thanks for pointing that out, I'll add it to the description.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, inner brim
Very nice model. I put a 4* rating because the top cover doesn't clips, find it a bit annoying.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, inner brim
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld