A simple display case for small items, that you can even hang on the wall. The dimensions are as follows:

h= 245 mm

w= 210 mm
d= 35 mm

Dimensions of any compartment is 200 x 35 mm.

It was printed with Bambulab Copper PLA Silk, following recommended directions by bambu wiki:

- Lower printing speed for outer walls: between 40mm/s to 60mm/s
- Increase hot end temperature: should be around 230 °C to 235 °C for best results;

- Acceleration: Normal printing at 5000 mm/s^2 and Outer walls at 3000 mm/s^2.

Obviously everyone uses their own parameters for PLA Silk, but lowering speed and acceleration gives better results.