Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
6 h
4 plates
Open in Bambu Studio
Boost
45
108
2
4
148
37
Released
Description
This is a Windmill or Windturbine. It designed it so it doesn't turn fast because in my region we have very fast winds. Therefore it's designed very tough.
For installation you need:
- 2x 608 Bearing
- 1x M8 threaded rod 1m
- 2x M8 Nuts
Then you put the nut on the threaded rod, then the bearings and at the top another nut.
After that you can slide the middle part of the windmill on that and glue the blades in the middle part.
You can also scale the model down if you want it smaller.
I printed my Windmill with PLA about 5 years ago and it's still holding up.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (2)