Stackable Build Trays - for "bricks"
Copyright Claim
Stackable Build Trays - for "bricks"
Boost
40
60
15
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
5.3 h
4 plates
Boost
40
60
15
0
95
157
Released
Description
Made some nice trays to organize your you know what bricks (I may not name the bricks) parts during building a set. Version for the small parts as well as larger parts.
Same sizes can be stacked on top each other for storage.
Sizes (currently):
15x20 cm
10x15 cm
10x10 cm
5x10 cm
Now even with a photo, to not be taken down again.
Print settings:
Filament: PLA
Layer height: 0.3 mm
Infill: 10%, cubic
Perimeters: 3
Support: not needed
Top/bottom fill pattern: monotonic lines
Top/bottom solid layers: 5/4
Remixing/Customization:
on demand
Comment & Rating (15)
All
The print profile is no longer public
Nice and easy printemps love it
0
Reply
The print profile is no longer public
Perfect for sorting larger kits when daughter and I build Legos!
(Edited)0
Reply
The print profile is no longer public
The designer has replied
0
Reply
hey, let me know what the issue was ;)
0
Reply
Hey, sorry it was all good but this app didn’t record my successful print only the first print that didn’t stick so I can’t rate above three stars
(Edited)1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
The print profile is no longer public
(Edited)
0
Reply
The print profile is no longer public
0
Reply
The print profile is no longer public
0
Reply
The print profile is no longer public
Support Issue:Issue with supports built into print profile, does not come off cleanly. Would recommend trying without supports if printer can support it or reduce the angle at the front
0
Reply
The print profile is no longer public
0
Reply
The print profile is no longer public
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld