Midcentury Planter
Midcentury Planter
Boost
717
1272
94
Print Profile(7)
Small, 0.2mm layer
Designer
4.4 h
1 plate
Large, 0.24mm layer
Designer
8.2 h
1 plate
Large, 0.2mm layer
Designer
9.4 h
1 plate
Small, 0.24mm layer
Designer
3.7 h
1 plate
Click to see more
Boost
717
1272
94
51
1.4 k
623
Released
Description
Midcentury planter with legs, available in two sizes with opening of 114 mm and 71 mm for a smaller pot.
Leg section has a fairly tight fit so does not really need superglue but you can also glue it if desired.
If you want to support me or get a commercial license you can join a patreon membership: https://www.patreon.com/SabreDesign
Check out more of my designs below and on my profile:
Comment & Rating (94)
All
Print Profile
Large, 0.24mm layer
sick pot, looks great in 2 color
(Edited)
0
Reply
Nice! Did you have to resize the planter to fit the monstera coaster plant?
0
Reply
Replying to @pieropenguin
it fits perfectly, I forget the exact measurements but it's a standard pot size and so is the monstera plants base.
(Edited)1
Reply
Awesome! I'll print the regular size then!
0
Reply
Print Profile
Large, 0.24mm layer
Perfect. thanks!!
1
Reply
Print Profile
Small, 0.2mm layer
The circular holder printed fantastically! The base, well that looked a bit ragged. My hunch is that it would have printed better if I had printed each part by itself and not together.
So I would recommend NOT printing on the same plate unless you choose to print by part and not by layer. My guess is that those rough edges would be cleared up.
The designer has replied
0
Reply
Thanks for the feedback, I havent had this issue on my printers with bambu filament but I will keep an eye out if more report this.
0
Reply
Boosted
This was a neat design, and different from the rest of the planters I've seen. Worked well for my cactus print 😊
0
Reply
Print Profile
Small, 0.2mm layer
perfetto
0
Reply
Boosted
Print Profile
Small, 0.2mm layer
fits perfectly
0
Reply
Boosted
Print Profile
Large, 0.2mm layer
Thanks. Easy to print.
0
Reply
Print Profile
Large, 0.24mm layer
Nice
0
Reply
Boosted
Print Profile
Small, 0.2mm layer
I but even more unusual, my wife, is so impressed with this model and print. loved it so much went full build volume (990g total 😅)
0
Reply
Print Profile
Small, 0.2mm layer
Great result!
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld