Remix of the Mini Splitter V2 for MMU2+1s by Ryper3D to work with ptfe clips instead of screws. It is slightly taller and wider at the top but it exactly the same at the base so there is no need to print those parts again.

Update: Added drawing with size for the right ptfe clip.

Update 2: Can't seem to find the right ptfe clips at Aliexpress so I change the splitter instead XD. It is bigger since the v6 1.75 clips I found are quite bigger.

Tested with the "MM-control-01-7-menosultralow.hex" and found out filament ends too deep inside the splitter causing trouble. In the ryper telegram group https://t.me/RYPER3D there is another firmware for the mmu board called “MM-control-01(7C).hex” that positions the filaments barely at the top of the splitter and appears to work perfectly fine.