Airsoft/Nerf Auto-Resetting Simple Target Remixed by ThePrinterPrinted

Remixed by

ThePrinterPrinted

Toys & Games>Outdoor Toys

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 100% infill

Designer

1.3 h

1 plate

3.9(10)

Target only, 0.2mm layer, 2 walls, 100% infill

Designer

44 min

1 plate

Open in Bambu Studio

Boost

Released

Description

All credit goes to Ray Fields over at printables. Not print in place, but

Use 100% infill, mine was printed with Prusament PLA and it can tank shots from a Tokyo Marui GBB pistol with no problems (300ish FPS). You can make it thicker (source file included) or stick something on the front to absorb the impact if shooting with something more powerful.
Wear protection and never shoot near pets or other people because BBs can ricochet in wild directions
Shoot the upper target to minimize the risk of damaging the frame
Fix it to something more heavy so it stays in place. No need to use precious filament just for dead weight so I made it pretty light.
If you want it to spin less, glue something to the bottom target. I made it pretty balanced to account for different weights and velocities of projectiles. Adjust it to your own needs!

Comment & Rating (10)

@mexbiker12

Print Profile

0.2mm layer, 2 walls, 100% infill

Qualität

@user_3519921476

Print Profile

0.2mm layer, 2 walls, 100% infill

I think it's too light and the nerf bullet breaks the construction when I hit it.

@LoganV

Print Profile

0.2mm layer, 2 walls, 100% infill

this is pretty cool! there may be a bit to much friction, because my dart zone max Stryker scooched it a bit with each hit.

@Romeo260

Print Profile

0.2mm layer, 2 walls, 100% infill

@Plaz

Print Profile

0.2mm layer, 2 walls, 100% infill

@mjrdcrker

Print Profile

0.2mm layer, 2 walls, 100% infill

Other Issues:The tolerances of the parts did not allow them to snap fit at all. Would have to glue the frames to the base. All the parts need to be redesigned for proper tolerances and snap fit.