Helldivers 2 Eagle Sweat Container
Copyright Claim
Helldivers 2 Eagle Sweat Container
Boost
52
85
13
Print Profile(2)
0.2mm layer *Added Support+6 walls+25% infill for pin/handle
Designer
4 h
5 plates
**Pause Added on container for non AMS
Designer
3.2 h
5 plates
Boost
52
85
13
7
105
31
Released
Description
EAGLE SWEAT…Don't just smell it…Live it
***UPDATED 3/31/24 - I added some profiles for the print of how I typically print. I also added a Profile with a Pause for non AMS to change the bottom container filament at layer 37. I recommend making sure the Pin and Handle have a 2 layer Raft for more consistent success.
Helldivers 2 Eagle Sweat container is my first 3D model! I am loving Helldivers 2 and this I found this commercial hilarious! This measures about 5 ¾ inches tall (146.05mm) and a little over 2 ¼ wide (60mm).
This comes with a twist top to make this a cool little container where you can store things to help you be a Hero of the Federation! Check out my socials for how it works!
Comment & Rating (13)
All
Awesome model. Came out perfect on my P1S. Don’t just smell it, live it.
The designer has replied
1
Reply
not only the eagle sweat but you can see the plane i the background
1
Reply
yo this is an awesome shot! I am happy it printed well for you. now go become a god among the cosmos *eagle screech*
1
Reply
Boosted
Print Profile
0.2mm layer *Added Support+6 walls+25% infill for pin/handle
had to print this so that I could smell like FREEDOM! FOR DEOMCRACY!
The designer has replied
0
Reply
FOR FREEDOM! Thanks for the rating!
0
Reply
Boosted
Print Profile
0.2mm layer *Added Support+6 walls+25% infill for pin/handle
Printed beautifully, just wish my shaky hands and old eyes could have done a better job painting the lettering. I printed in PETG
The designer has replied
0
Reply
I struggle with that as well when making orders of them lol. the AMS time and waste is not worth it to me though.
0
Reply
Print Profile
0.2mm layer *Added Support+6 walls+25% infill for pin/handle
The designer has replied
1
Reply
looks great! 🦅🫡
0
Reply
Replying to @nerddad3d
Thankyou :)
0
Reply
Boosted
Print Profile
0.2mm layer *Added Support+6 walls+25% infill for pin/handle
0
Reply
Print Profile
0.2mm layer *Added Support+6 walls+25% infill for pin/handle
1
Reply
Print Profile
0.2mm layer *Added Support+6 walls+25% infill for pin/handle
Strength Issue:snapped in half removing from bed, at this point re-printed about 4 times so just glued it back together
Missing Model Parts:much of text not showing up in sliced parts, had to correct by repositioning and rescaling. made text embed into part following poor quality on first couple attempts with positive results
Other Issues:pin model proving to be impossible to get a print of, may be geometry issue rather than profile
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld