Toilet roll inverse dispenser by Meco17

Meco17

Household>Decor

GIF

Print Profile(2)

All

P1P

P1S

X1 Carbon

X1E

0.2mm layer, 3 walls, 15% infill

Designer

4.5 h

2 plates

5.0(3)

0.2mm layer, 3 walls, 15% infill +20 mm

Designer

1.4 h

1 plate

Open in Bambu Studio

Boost

Released

Description

Hello everyone, this is my new creation, an unusual toilet paper dispenser with inverse unroll. Personally I think this keep it more clean and igienic.

It has an indicator that shows how many paper left.

Easy to print, no supports (I used pla+ from sunlu), layer 0.2 is percfect for the interlockings.

For the Toilet Paper with standard size you need to take off the cardborad in the centre like the GIF, then put the roll inside the dispenser and close with the cover by pushing it. That's all!

Max toilet paper size is 130 mm diameter and 100 mm height.

Soon i'll add an higheter cover for bigger rolls.

UPDATE

Added an highter cover (+20 mm)

Hope you all enjoy my creation!

Meco

Comment & Rating (6)

@user_3880420919

Print Profile

0.2mm layer, 3 walls, 15% infill

perfekte Vorlage, guter Druck , man könnten den Durchmesser nach den Papierrollendiameter ändern

(Edited)

The designer has replied

@Meco17

Thank you so much!

(Edited)

@1darkprince

Print Profile

0.2mm layer, 3 walls, 15% infill

turned out fine but this will not fit a Charmaine Toilet paper roll

(Edited)

The designer has replied

@Meco17

i'm so Sorry for this, i tried with Foxy and scottex toilet paper (Italy). I Googled too the standard size Rolls and It was fine. anyway I Will add the maximum size in the description and later make an highter container versione. Thank you for the feedback!

(Edited)