I wanted a container with a lid to store cartridges without using the little silicone caps they give with them. After designing a couple singles, I decided to make a larger one. This is built for up to 5 cartridges and should fit any 1g cartridges on the North American market. Will not fit 1.2's. 

The base and the lid are two separate files and can be printed separate from each other. 

The base is tapered and will press fit together. Knock it on a table or press one of the sides to open it once it has been pressed on. 

I printed this at a 0.2-0.28 layer height. With PETG I had best results with 0.24mm, but PLA will work perfectly as well. 

I hope you like it!