Lens Cover For Milwaukee M18 Rocket Light by CK Designs

CK Designs

Tools>Other Tools

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

1.7 h

1 plate

4.9(9)

Open in Bambu Studio

Boost

105

Released

Description

This is a cover that is designed to snap onto the Milwaukee M18 Rocket Light. I have added a 10mm hole for use of carabiner or other types of holders so it can be attached to the handle of the light while not in use. I printed this in PLA and PETG and I would recommend printing it in PETG. They both fit perfectly fine but PETG has a little more give and would probably have a lower chance of snapping the tabs off over time.

Comment & Rating (14)

@XOakX

Boosted

printed nicely with ABS. boosted cause I use a lot of your models .. you do good work. Forgot to rate it when it came out but it's good. I think most models I see say PLA. BIT I PRINT PETG OR ABS on stuff that could see heat in a vehicle or repeated impact like your supports. PLA may be fine for a control temp garage...

(Edited)

The designer has replied

@CK_Designs

Thanks I appreciate it!

@shredder646

i printed it with PLA and tabs broke right off going to try it again

The designer has replied

@CK_Designs

Hi! When installing it and taking it off I recommend to hook the two tabs opposite to the one with the hole first and then use the tab with the hole to push down last. I also printed mine in petg to give it a little bit more give. I am going to be uploading an updated version of this though because I added a little bit more material in the corners.

@bisonburger

Print Profile

0.2mm layer, 2 walls, 15% infill

great print, used pls white and it acts as a diffuser when you don’t need full brightness.

@Drabjeep00

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

Perfect fit and easy to put on and off.

@user_2301376358

Print Profile

0.2mm layer, 2 walls, 15% infill

easy and great cover

@CanadianMommy

Print Profile

0.2mm layer, 2 walls, 15% infill

fits perfeft

@ColeAwsomePrint

nice will be printing! this light rode around with me many of times wish I thought of this!

@declinelens0m

Print Profile

0.2mm layer, 2 walls, 15% infill

@user_3015430084

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

@nathan.richards

Print Profile

0.2mm layer, 2 walls, 15% infill

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.