eSUN Filament Refill Spacer for BambuLab Reusable Spool
Copyright Claim
eSUN Filament Refill Spacer for BambuLab Reusable Spool
Boost
18
52
8
Print Profile(1)
0.6mm nozzle, 0.42mm layer, 2 walls, 20% infill
Designer
54 min
1 plate
Boost
18
52
8
0
95
69
Released
Description
A small spacer to place on the Bambu Lab reusable spool when using the eSUN filament refills. Friction fit to the spool and cardboard tube inside the filament refill. Stops the filament from freely spinning and bouncing around.
Comment & Rating (8)
All
Print Profile
0.6mm nozzle, 0.42mm layer, 2 walls, 20% infill
Printing was fine, in fact I was able to change to Bambu Lab Spool without this component. eSUN's Spool specifications may have changed.
0
Reply
The print profile is no longer public
print came out very nice and works as it should
0
Reply
can this be used to transfer esun cardboard spool to bambu spools....
0
Reply
Print Profile
0.6mm nozzle, 0.42mm layer, 2 walls, 20% infill
Doesn't fit. Just a waste of filament
(Edited)0
Reply
very good!!!
0
Reply
The print profile is no longer public
Fits prefect! Printing was good.
(Edited)0
Reply
Print Profile
0.6mm nozzle, 0.42mm layer, 2 walls, 20% infill
Other Issues:The Part printed fine, but did not fit the spool. this might be due to the different tolernaces that come with the 0.6 nozzle.
0
Reply
The print profile is no longer public
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld