A simple cutting board wall mount made specifically for the 2 piece Meijer Grand Gourmet 2 set cutting board but can also work with other cutting boards with handles. The screw I used to mount it is a #8x3/4 particle board screw. But, depending on the material you used, you can sand the back of it smoothly to use a heavy duty double sided sticky tape to mount it to the wall instead. I used a screw because it fell down after a day with just double sided tape.

I printed this using various filaments from PLA to PETG and finally, ASA. The one I featured in the picture is the latest one with ASA using 100% infill. You can use far less infill as I also use this as a form of benchy/test to configure my printer. I also use OrcaSlicer with tree supports enabled for the overhang/lip that keeps the cutting boards from falling forward. Tried printing this without supports and that lip didn't print right. So highly suggest printing with some type of support. Printing took just over 2 hours but you can cut 30 minutes off if you set the infill down to 20% or so.

The width of the inner section measures 97mm or 3-13/16". So it can fit other cutting boards that have a bigger handle opening.