Poop Chute Bag Holder for P1S / P1P (Easy mount)
Copyright Claim
Poop Chute Bag Holder for P1S / P1P (Easy mount)
Boost
6
9
5
Print Profile(2)
0.4mm nozzle 0.24mm layer, 20% infill, PLA, edited support.
Designer
1.3 h
1 plate
0.6mm nozzle, 0.24mm layer, PETG, Edited support
Designer
1.6 h
1 plate
Open in Bambu Studio
Boost
6
9
5
1
11
11
Released
Description
A good first print for your printer!
Only uses ca 50g of material.
Don´t use all your filament to print a big poop chute container. Print this instead and save money!
I suggest using the free bags from the supermarked, otherwise use the thin garbage bags.
Assemble the parts by following the pictures.
The bag should be mounted in the bag clamps while hanging down vertical, and as shown in the pictures. otherwise it might block the poops.
Please give me a rate thanks :D
(i also have a poop chute filament bag holder for recycling filament bags)
Comment & Rating (5)
All
Print Profile
0.4mm nozzle 0.24mm layer, 20% infill, PLA, edited support.
print went fine no problem mounting on my P1S but didn't work as expected since the P1S got constipated and popped the lid.
The designer has replied
0
Reply
do you mean the bag holder blocked it? remember to mount the bag in the upright position, so there will be no folds in the plastic bag that stops the poops. thanks for downloading!
(Edited)1
Reply
thank you! downloaded!
1
Reply
Print Profile
0.4mm nozzle 0.24mm layer, 20% infill, PLA, edited support.
The designer has replied
0
Reply
Thank you for the rating!
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld