A1 mini Filament holder

A1 mini Filament holder

Boost
122
274
54

Print Profile(2)

All
A1 mini
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
2.3 h
1 plate
4.8(40)

0.12mm layer, 3 walls, 8% infill
0.12mm layer, 3 walls, 8% infill
4.3 h
1 plate
4.8(4)

Open in Bambu Studio
Boost
122
274
54
29
463
279
Released

Description

Boost Me (for free)

Want to se more models from me? Feel free to give me a boost to support my work. 

 

V2 I have updated the clip and made it stronger.  

Bambu lab A1 mini filament holder/Spool holder. I found the original filament holder too small and therefore I designed a bigger and better fitting holder that replaces the original.

 

To install the new filament holder first remove the holder from the machine. Then press on the clip on the original holder as seen on the picture below.

Now just install the new holder on the orginal grey pary as seen in the picture below.

Now it's finish you can now install the holder on the machine again.

 

Comment & Rating (54)

Please fill in your opinion
(0/5000)

I've searched high and low for something reasonable like this, and this works perfectly. this printed flawlessly and snapped into place without forcing it. Thank you.
(Edited)
The designer has replied
3
Reply
Thank you for the comment! What brand is the filament?
0
Reply
Replying to @PrintByMelle :
It's Ender PLA
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
good
1
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
passt super
1
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
I'm so glad I found your model. I didn't even know the handle was detachable. I hope you don't mind, I've added a print profile so that it fits Elegoo spools too. All the rewards will go to you. Thank you for your work.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice design!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Very nice stuff! Thanks.
1
Reply
printed perfectly!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Thank you, absolutely essential, A1 should come like that, i had massive problems with Filament entangling and its GONE with this Holder. (That securing clip broke when inserting though, using Bambu Pla Basic but it sits tight enough, dont want to glue to be able to reverse)
(Edited)
The designer has replied
2
Reply
Thanks for the feedback! I have updated the model with a stronger clip that should not break.
2
Reply

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.