Nuka Cola Bottle Cap - Oversized - Shell
Copyright Claim
Nuka Cola Bottle Cap - Oversized - Shell
Boost
11
19
12
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
41 min
1 plate
Open in Bambu Studio
Boost
11
19
12
0
73
35
Released
Description
Oversized bottle cap - Nuka Cola
Not tested below the file scale so 104% works for the lettering detail.
Comment & Rating (12)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
perfect
The designer has replied
0
Reply
Looks great!
0
Reply
I had gaps in the white part of the lettering, did not scale
The designer has replied
0
Reply
It will be a problem in your filament profile and flow rate. Calibrate every filament you use. :)
0
Reply
Replying to @Laserforgeinfo
I always calibrate but you may be right. I'll further calibrate and see what results I get. at any rate thank you for taking the time to provide this model, much appreciated, just providing some feedback :)
0
Reply
Replying to @Laserforgeinfo
Perhaps, but with my P1S and the filament used I've had no issues of this nature except with this print file and the lettering. Thanks for the file, I will give it another shot ;)
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
prints well doesnt scale great but was probably something i did.
The designer has replied
0
Reply
Thanks for the rate! - I didn't really design it go smaller on this occasion but I might design a life size one soon :)
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
© 2024 MakerWorld