Mclaren P1 Scale Model
Copyright Claim
Mclaren P1 Scale Model
Boost
4
5
4
Print Profile(1)
0.8mm nozzle, 0.16mm layer, 2 walls, 15% infill
Designer
5.7 h
1 plate
Open in Bambu Studio
Boost
4
5
4
1
12
6
Released
Description
mclaren p1 5cm long
Comment & Rating (4)
All
Print Profile
0.8mm nozzle, 0.16mm layer, 2 walls, 15% infill
Strength Issue:Mainly the thinner sections where prone to snap. I had to glue them and solder the bottom surface as it was not on the build plate in some sections.
Support Issue:Very difficult removal process. But that is the same across all detailed models. It would be good if there was an optimizes profile for this issue.
Other Issues:The wheels did not come out well first attempt. I will try and fix the model as the wheel centres came out when I tested them.
0
Reply
It is a great model. However I dislike the fact you need lots of post processing and the bottom surface is not the best. Everywhere else it's very good. Just stronger connections in some spots too.
0
Reply
Print Profile
0.8mm nozzle, 0.16mm layer, 2 walls, 15% infill
Support Issue:The support's they stuck to the model
The designer has replied
0
Reply
Not for me -- It might be due to my filament. I'll try again and update you. Thanks for the feedback!
0
Reply
No more
License
This user content is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld