Search models, users, collections, and posts
A1 Mini Cable Guide
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
46 min
2 plates
Open in Bambu Studio
Boost
20
36
11
3
85
73
Released
Description
Hello everyone,
A cable holder for an A1 Mini, it stops the cables from getting stuck behind the main post.
Specifications:
Printer: A1 Mini
Infill: 15% (Lower infill may also work)
Supports: No
Nozzle: 0.4mm
Layer Height: 0.2
Material: PLA
Note:
The holder does a great job of keeping the cable at a 45-degree angle, which prevents any sharp bends. Just remember, it's meant for the printer cable only. So, I suggest using clips or cable ties to keep both the cable and the PFTE tube together. I added 2 parts one standar fit and one that fits very tight. (I am using the standard)
Happy printing!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (11)