Dewalt Battery Holder
Copyright Claim
Dewalt Battery Holder
Boost
31
83
12
Print Profile(3)
0.2mm layer, 3 walls, 20% infill
Designer
1.3 h
1 plate
Fixed Z Offset 0.2mm layer, 3 walls, 20% infill
1.4 h
1 plate
A1 mini Variant
1.8 h
1 plate
Open in Bambu Studio
Boost
31
83
12
2
183
152
Released
Description
Battery holder for dewalt 20v
Print at 102%
Comment & Rating (12)
All
Print Profile
0.2mm layer, 3 walls, 20% infill
Printed spot on, battery a little loose fit but can be rectified with a bit of foam or rubber padding of some sort.
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
a perfect fit for the tools. vertical makes it print very cleanly
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
Printed perfectly in both PLA and PETG. Thank you!
1
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
A must have for anyone with lots of batteries but limited charger space. I printed them in green and red for charged and need to be charged. Ill never grab a dead battery again!!! lol
1
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
came out perfectly
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
Perfect surface finish, excellent fit!
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
Fixed Z Offset 0.2mm layer, 3 walls, 20% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld