Top glass riser BambuLab Emboss *V2* [P1S and X1C]
Copyright Claim
Top glass riser BambuLab Emboss *V2* [P1S and X1C]
Boost
164
302
125
Print Profile(4)
0.16mm layer, 2 walls, 15% infill
Designer
34 min
1 plate
Basic PLA Print - 0.2mm layer, 2 walls, 15% infill
23 min
1 plate
PETG - For Medium Heat Resistance
43 min
1 plate
ASA/ABS - For maximum heat resistance
23 min
1 plate
Open in Bambu Studio
Boost
164
302
125
23
798
546
Released
Description
Find V3 here: https://makerworld.com/en/models/423637#profileId-326893
Version 2 of my top glass riser. I added a bambulab emboss for aesthetic reasons.
Cleanest and most simple top glass riser out there (in my opinion). No support necessary, 15% Infill, quick and easy print.
For the P1S, likely also works on the X1C.
Comment & Rating (125)
All
Print Profile
Basic PLA Print - 0.2mm layer, 2 walls, 15% infill
Without support it's not perfect
The designer has replied
1
Reply
supports? mine comes out great without them!
0
Reply
Replying to @Roket_1
as you can see in the upper part without the aid of supports the piece is slightly damaged
0
Reply
Replying to @Roket_1
as you can see in the upper part without the aid of supports the piece is slightly damaged
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Perfect
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
model printed flawless
1
Reply
perfect
1
Reply
Came out perfectly in some old translucent red PETG i had lying around. Hopefully this helps to ventilate and reduce the amount of clogs I keep getting recently!
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
perfetto
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
good print profile
0
Reply
no supports needed, just print it sideways, came out fine - very simple!
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
I use it everytime time i print!
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Really quick
0
Reply
License
This user content is licensed under a
Creative Commons Attribution
© 2024 MakerWorld