Search models, users, collections, and posts
Mini Flag Holder
Print Profile(2)
0.2mm layer, 4 walls, 50% infill
Designer
20 min
1 plate
Normal 0.2mm layer, 2 walls, 15% infill
Designer
15 min
1 plate
Open in Bambu Studio
Boost
40
91
12
4
350
288
Released
Description
I made this flag holder that a small flags vertically. I printed it at 50% infill to make it heavy and sturdy however if you don't want to waste material you can just use 15% infill and it still works fine. This print requires no supports. The flags stick in nice and snug and don't fall out. If you want a holder that hold two check out my other design here:
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (12)