Pen Spinner (No Pennies)
Remixed by
Copyright Claim
Pen Spinner (No Pennies)
Remixed by
Boost
1
0
2
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
1.3 h
1 plate
Open in Bambu Studio
Boost
1
0
2
0
1
2
Released
Description
(Not actually a pen)
I wanted to make a spinner that felt satisfying to spin between my fingers.
I also added rounded indents at the top and bottom that feel satisfying to touch.
The model should also be printed at a slower speed because it can fall over as you get higher up.
This version of the model prints without pennies but feels worse to spin because its lighter.
Penny Version: https://makerworld.com/en/my/models/389135/edit
Comment & Rating (2)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
printed on my A1 using bambu filament without issue.
came out great, but I wish I went with the pennies version
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld