Easter Bunny Slinky Toy - Print in Place
Copyright Claim
Easter Bunny Slinky Toy - Print in Place
Boost
110
145
18
GIF
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
4.5 h
2 plates
0.2mm layer, 3 walls, 15% infill
1.6 h
1 plate
Open in Bambu Studio
Boost
110
145
18
3
264
187
Released
Description
This model is print in place. You can print it as is and can be pulled apart when it is done printing. Be careful pulling it apart so you don't stretch it out.
PLEASE NOTE: Bambu Studio will give a warning about floating cantilever. You can ignore that, it will print fine.
I printed mine in PLA however for longevity, it may be better to use something like PETG.
There are two build plates in the print profile. One is single colored and the other colors in the eyes and nose.
Good luck printing!
Comment & Rating (18)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
I initially had a problem printing to the rabbit's ears but it was due to the alignment of the plate
(Edited)
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
printed perfectly
0
Reply
did a testprint with Geeetech tricolor silk filament. Came out wonderful. Lovely print. Thank you for sharing
0
Reply
I was very skeptical of this design as I’ve never seen a 3d printed slinky. very happy with the result, printed perfect on the first try and is surprisingly durable. Great design!
1
Reply
Boosted
I made 10 of these. They were a huge hit! So fun.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
My daughter loved it.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
made this for a bunch of family members for Easter & they all loved it!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld