Pumpkin Tealight patty remix
Remixed by
Copyright Claim
Pumpkin Tealight patty remix
Remixed by
Boost
10
12
11
Print Profile(2)
0.12mm layer, 3 walls, 8% infill
Designer
3 h
2 plates
Fast and fine 0.16mm layer, 2 walls, 10% infill
2 h
2 plates
Boost
10
12
11
0
38
61
Released
Description
You need support for the tooths. I used 0.12 layer, 3 walls and 8% gyroid infill.
Added also Multicolor mf3
Remixed original v2 to flat hat so no support needed for the stem
Comment & Rating (11)
All
Print Profile
0.12mm layer, 3 walls, 8% infill
very nice print. Lower part of the teeth could be a tad better, but hard even with supports to get this great.
0
Reply
Print Profile
0.12mm layer, 3 walls, 8% infill
Perfect
0
Reply
Print Profile
0.12mm layer, 3 walls, 8% infill
Perfect print. Good for kids.
0
Reply
Print Profile
0.12mm layer, 3 walls, 8% infill
great design for halloween 👍🏻 with electric candles is very funny and good looking 👍🏻
0
Reply
Print Profile
0.12mm layer, 3 walls, 8% infill
In PLA, i make the complete on one plate with supports only on the bottom, works perfectly
0
Reply
Print Profile
Fast and fine 0.16mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.12mm layer, 3 walls, 8% infill
0
Reply
Print Profile
0.12mm layer, 3 walls, 8% infill
0
Reply
Print Profile
0.12mm layer, 3 walls, 8% infill
0
Reply
Print Profile
0.12mm layer, 3 walls, 8% infill
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld