Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
4.1 h
1 plate
Boost
92
164
10
5
149
70
Released
Description
Tealight candle model.
Comment & Rating (10)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
look really good, only bit small
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
looks so moody in the living room
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
would leave been a 5 but the bottom few layers after the base was stringing filament all around it. but it did finish and is very pretty in the dark nice model, am curious to see how pla holds up though 🤣
0
Reply
can it be printed in vase mode?
0
Reply
Hello, on the file there are not the two models? Would it be possible to have them? Thank
0
Reply
How do you print the taller one
0
Reply
Boosted
Nice design
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Public DomainRelated Models
© 2024 MakerWorld