Hi!

This is my Customizable hook for all purposes.

You can open the Fusion360 file and change the parameters for your own need!

Mine was printed for a squeegee, but you can also make them for a towel, or whatever fits your needs!

I printed mine without supports, as the diameter was big enough.

You can print them in whatever material you like, its all up to you :).

In the 3mf file I made use of the adaptive layer lines, to make the hook look even nicer.

I suggest you do the same for the parts where the radius turns into the straight piece.

For the squeegee holder 30 % infill was more then enough, but you could use more if it suits you.

I printed mine in PLA first to check the fit, and then in ASA for using it in the bathroom.