Search models, users, collections, and posts
Spherical Dice
IP Report
Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
2.1 h
1 plate
Open in Bambu Studio
Boost
3
6
3
0
16
7
Released
Description
Spherical Die that WORKS!
Check out the video here:
YOU MUST NEED a small ball of some sort (Marble, metal ball, etc.) that will act as the weight inside the 3D print to make it work.
In the 3mfs, There is a pause about halfway through the print for you to insert the weight ball.
3 sizes: small, medium, and large (This depends on the size of your ball; 13 mm (½ inch) marble corresponds to medium)
Note: If the model is too large compared to your weight, it wont work as well. If the model is too small, the weight won't fit.
Settings:
Supports: Yes
---------------------
Fuzzy Skin: Optional
--------------------
Brim: No (Supports are sufficient)
--------------------
Layer height: 0.05-0.10mm
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (3)