youtube short

Prints with no support. Print orientation is as imported. Print settings: .2 or .4 layer height. 3 walls // 20% gyroid infill. No additional scaling should be necessary.

Mounting instructions: *Slider mounts under desk nicely with 1" drywall screws (using 2 should be enough), or double sided tape (good tape HERE). See ‘easy finger access’ photo for ideal slider mount installation orientation. Snap slider in mount before installing the mount under the desk..

** Unfortunately MakerWorld doesn't allow me to link you to my commercial printing license, I do have one however as I am a professional. If anyone is interested in contacting me in regards to the license or about the designs themselves you can find me @Snail on Printables. That is mainly where I am active, comments on my makerworld profile will likely go unanswered.