Raspberry Pi 5 Case with logo - snap fit
Remixed by
Copyright Claim
Raspberry Pi 5 Case with logo - snap fit
Remixed by
Boost
2
4
3
Print Profile(4)
Red and green bottom - 0.2mm layer, 3 walls, 15% infill
Designer
3.1 h
1 plate
White and red bottom - 0.2mm layer, 3 walls, 15% infill
Designer
1.8 h
1 plate
Bottom case only - 0.2mm layer, 3 walls, 15% infill
Designer
48 min
1 plate
Top case only - 0.2mm layer, 3 walls, 15% infill
Designer
1.4 h
1 plate
Open in Bambu Studio
Boost
2
4
3
2
12
10
Released
Description
This is a remix of dgauche's Raspberry Pi 5 with official active cooler case. I added more cooling vents and a vent in the shape and colors of the Raspberry Pi logo.
This case will work with the Raspberry Pi 5 with and without the official active cooler. The case is snap fit and fits together snugly. No screws are needed to hold the case in place. There are optional holes in the bottom to secure the case with four M2.5x8 countersunk screws, but this is unnecessary and optional to the user.
This print is set up for three colors using an AMS. It can also be printed single color if desired. No supports are used for printing.
Horizontal stand for this case: RASPBERRY PI 5 HORIZONTAL STAND by Siam3D - MakerWorld
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld