Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
3 h
1 plate
Open in Bambu Studio
Boost
8
6
5
6
43
40
Released
Description
Original creator: ozelotbeaver
Belt clip holder for snusdosor, designed to fit standard Swedish Match type boxes. The two parts snaps into place. Make sure to orient the pieces to constant cross-section when printing (put the parts flat down on the print bed, not like it's shown in the preview for the springy part)
Comment & Rating (5)
All
Boosted
addiction is good
0
Reply
Boosted
zyncredible
0
Reply
Love it but needs a ridge or catch so when you try to grab the snus can the entire assembly doesn't come off your belt with it.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld