Print Profile(1)
0.2mm layer, 2 walls, 10% infill
Designer
5.7 h
22 plates
Open in Bambu Studio
Boost
22
39
8
0
71
14
Released
Description
easter night light
Cute bunny plus egg-shaped puzzle with cross three-dimensional layers. It looks very good on the table.
The assembly and overlapping method is as shown below. Just overlap and assemble according to the numbers.
Comment & Rating (8)
All
this video will help you to make it to the end to finished it. In files you have names for every part.
first layer (happy Easter) is wrong side on the picture.
https://youtu.be/RyZEIp8x3FE?si=MlxDT3V6pNuIuHT3
i think one part have a mistake, but i finished it.
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
The assembly instructions are very confusing.
Also, can you give us some indication of how you did the lighting?
The designer has replied
0
Reply
The light strip is mounted on the base
The base has space to install any device that can emit light
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
impression sympa mais impossible de l'assembler
0
Reply
L’impression est bien mais impossible d’assembler le modèle, aucun notice de montage cest incompréhensible
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
instructions should be reworded, but the print is excellent
0
Reply
Start assembly with 6A and 6B, and move forward note the CAPITAL Letters and lower case letters the CAPS are closed parts and the lower case are open parts the larger the number the smaller the part
(Edited)0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld