Print-in-place latch with catch
Copyright Claim
Print-in-place latch with catch
Boost
20
35
1
Print Profile(1)
0.2mm layer, 3 walls, 30% infill
Designer
45 min
1 plate
Open in Bambu Studio
Boost
20
35
1
0
26
15
Released
Description
Simple print-in-place latch that can be attached with Command Strips. Use for whatever purpose suites, however I created this specifically to hold open a pocket door that likes to close on its own without it.
Comment & Rating (1)
All
Print Profile
0.2mm layer, 3 walls, 30% infill
first print was tangled up spaghetti. second came out perfekt. probably old filament problem.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
© 2024 MakerWorld