The model in the Print Profile doesn't need glue or extra pieces for assemblage.
Dovetails are calculated to assemble it solidly but not in a permanent manner.
1) Joint all pieces (Base and Ring)
2) Add The Magnets
2b) Optional - Add the rubber strip at the top of the base
3) Put the LEDs in Place. Use the Hole on the bottom to pass wires
4) Add the Led Opale (Printed or Buyed)
5) Connect the Ring at the Base with the Metal Pin
6) Remove the Printer Glass
7) Put it in Place and adjust it until you feel magnets make a strong connection
9) Put the Glass on it
New profile for Extra Piece with fontal Lip for everyone who is not confident because of the glass.
New Profile with Ventilated Frame
The model is created to be updated with accessories or alternative pieces, think about that if you want to glue it.
If you have some good ideas about improvement feel free to make suggestions in the comment
A video is worth a thousand words.
__________________________________________________________________________