This is my take on a case for an RPI 3B+ attached to a BTT TFT50 v2.1 screen with ventilation and access to the screen buttons. Useful for a remote klipper screen install, Homeassistant dashboards or anything a little touchscreen computer can do!
I wanted to create a remote klipper screen touch screen device to control my 3D printers that was not attached to the printers themselves to place on my work desk.
However I could not find an enclosure that met all my requirements:
So this design was born!
While I have configured it to run klipper screen, this little stand alone computer can run the rPI desktop operating system and hence, can act as a touch tablet for any use - Homeassistant dashboards, a mini tablet or custom voice assistant. Basically anywhere you'd like a small computer with a touch screen!
Print with the below settings in your favourite slicer:
This case has a tight and precise fit to the BTT TFT50 screen and RPI charging cable, so if your printer is out of tolerance it may take a little more persuasion for the snap fits to push together.
Firstly assemble the rear panel by gluing the foot to the bottom rear as below:
Install the DSI cable to the screen and the RPI. Also install your SD card and operating system. You want to do this prior to installing it in the case as it will be fully enclosed with no access to the SD card once assembled.
Install the screen in the case and push firmly to seat it against the mounting tabs. These are friction fit so some slight force may be required to firmly secure the display in its place
Then proceed with mounting the RPI to the rear of the screen as below:
Finally push the rear cover on and secure with the snap fit connectors
Your mini computer is now fully assembled
Last step is to plug it in from the cutout on the top of the case. Any small factor micro USB connector should work well for this with adequate clearance.