Cascade card wallet V2 _ ID card + ring + Airtag
Remixed by
Boost
14
15
9
Print Profile(2)
with/without Airtag holder 0.2mm layer, 2 walls, 15% infill
Designer
4.1 h
2 plates
no airtag holder - 0.2mm layer, 2 walls, 15% infill
Designer
1.8 h
1 plate
Open in Bambu Studio
Boost
14
15
9
2
55
36
Released
Description
New update! added an airtag holder
Just added ring for lanyard and +2 ID card holder on Hugo's nice work. (So this can hold up to 8 cards)
As I used Bambu studio to modify the file, do not remove a negative part-Cylinder. This is for separating lever shaft from ID holder parts.(Please see 2nd photo)
You can relocate ring as your favour-in object view mode.
Tree supports are only needed under ID card part (and airtag holder). Custom support is already set in this profile.
Comment & Rating (9)
All
Print Profile
no airtag holder - 0.2mm layer, 2 walls, 15% infill
I had to print several times to figure out which size work best. the original size was too small.
The designer has replied
0
Reply
I have printed several as well and all fits well. What material did you use?
0
Reply
Print Profile
with/without Airtag holder 0.2mm layer, 2 walls, 15% infill
Printed it with an AirTag. I’ve been using it for a month now. No issues.
0
Reply
is that "noongom" id holder also 3d printed?
The designer has replied
0
Reply
It is printed with Badge ID card printer.
0
Reply
Boosted
Print Profile
with/without Airtag holder 0.2mm layer, 2 walls, 15% infill
fantastic
0
Reply
Print Profile
no airtag holder - 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
with/without Airtag holder 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
no airtag holder - 0.2mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld