Jewelry case for earrings (print in place)
Jewelry case for earrings (print in place)
Boost
8
7
2
GIF
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.8 h
1 plate
Open in Bambu Studio
Boost
8
7
2
0
6
3
Released
Description
So here is my “Jewelery Box” with a hinge and print in place for earings!
The box is 20 mm height and 100 mm x 100 mm big.
No Supports needed!
The 9 square compartments have a dimension of 20mm x 20mm!
On my pictures you see a big “M” on the top of the case. This M is not in this version of the model!
If you need a special text or letter please send me a comment or a message!
Magnets needed:
Two magnets with a height of 2 mm and a diameter of 6 mm must be glued in!
The other pocket in the middle is for a smaller magnet ( 2 mm height and a diameter of 6 mm) (for the case, that the two other magnets not strong enough!)
Comment & Rating (2)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed very nicely. A bit small, but my wife loves it. Magnets fit perfectly!
The designer has replied
0
Reply
thank u so much!
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld