Remix of https://www.thingiverse.com/thing:2938514

I extended the bottom edge to 7.5mm for a little more protection from mud and water, and made the grips on it extend out a little further from the original. This has a great feel in the hand and should work great with gloves.

Support setting modified in the print profile for easier removal. Tweak these to your preference if desired. Add a brim if adhesion is an issue (rarely is with TPU)

Printed in Overture TPU, but I'm sure PLA/PETG or others would work well. Clean up the supports and any blobs/stringing with tweezers, pliers, xacto blade, etc.