I designed this saucer to put coffee mugs on it.

The outlines are drawn with the word coffee in French and English.

The saucers are stackable, which allows you to print several and store them on top of each other without slipping.

There is also a non-stackable version.

I haven't tried printing it without supports.

And on the photos you can see that I designed & printed it when I was using my previous 3D printer, a Makerbot Method with PVA as a support (dissolution in water in about ten hours max).

I have already used PVA with my Bambulab and it works pretty well (even on the AMS), so I suggest to use it to print this saucer.

I have added a profile that allow to use less support (again use PVA for a better result), with arborescent type & support only critical areas settings.