AMS PTFE feeder cap
Remixed by
Copyright Claim
AMS PTFE feeder cap
Remixed by
Boost
17
29
15
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
14 min
1 plate
Open in Bambu Studio
Boost
17
29
15
1
91
81
Released
Description
The original model wouldn't fit my PTFE, and cracked when I put it on, so I redesigned it. Printed in ABS.
Comment & Rating (15)
All
Fast to print and good design.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Cleanly printed. Clipped on firmly - looks like these will do their job well.
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Best design out there. All the others fall off as they try to cover the button.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Good.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Can't go wrong with this one
0
Reply
Printed quick, clips on tight, but isn't too hard to put on. Tubing fits well. Great design. Worked just fine in PLA.
Thanks for taking the time to design this. I tried 3 others before finding yours. None of them would fit correctly.
One question. How long should the tube be that's coming out of the top be to help prevent the spool from hopping when it gets low?
(Edited)0
Reply
These are the simplest caps out there that do the job and don't fall off. The others fall off eventually because they cover the button part with a cap (and usually a stupid logo) which loosens up as the feeder moves forward and back with the button. Sorry it won't let me give you a rating for some reason but I would give you 5 stars if I could!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld