DaVinci Bridge Puzzle Set
Copyright Claim
DaVinci Bridge Puzzle Set
Boost
25
53
6
Print Profile(1)
1 set, 0.2mm layer, 2 walls, 15% infill
1.4 h
1 plate
Open in Bambu Studio
Boost
25
53
6
0
41
50
Released
Description
Each beam has 2 cut-outs on one side and 1 on the other. Face the side with 1 UP.
Took me a few tries to figure out how to put it together. If you insert the crossmembers, you can lift them to insert the next set of beams.
Yes you can put more than 2 sets together but remember the angle of gravity will change with size. You might have to tie the ends.
Comment & Rating (6)
All
Just a FYI that if you twist the rods - then the angles will print much nicer on top and bottom.
I'd like to take credit for revealing/learning this - but BambuStudio's 'Auto Arrange' do the magic for me!
The designer has replied
0
Reply
Oh man that's pretty smart. I should've caught that =)
0
Reply
Print Profile
1 set, 0.2mm layer, 2 walls, 15% infill
Spot on profile
1
Reply
Nice print in burly wood pla+
0
Reply
Print Profile
1 set, 0.2mm layer, 2 walls, 15% infill
Other Issues:didn’t stick to bed no matter what I did
0
Reply
Print Profile
1 set, 0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
No more
License
This user content is licensed under a
Creative Commons Public DomainRelated Models
© 2024 MakerWorld