The Gryphon Foam Dart Blaster by Flygonial

The Gryphon Foam Dart Blaster by Flygonial

Boost
27
51
7

Print Profile(2)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

Revised supports + Wire Run
Revised supports + Wire Run
Designer
16.1 h
3 plates
4.8(4)

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
26 h
3 plates

Boost
27
51
7
2
108
24
Released

Description

There are so many mods and parts that go with this foam dart blaster so I decided to compile a single .3mf that is painted and supported with support filament. This was setup for the p1s, you can also find all the files here https://github.com/Flygonial/The-Gryphon-Foam-Dart-Blaster

Comment & Rating (7)

Please fill in your opinion
(0/5000)

@israelflores Before I print this i wanted to know if it can shoot actuall nerf bullets
The designer has replied
0
Reply
Yup, if you print the .3mf that with all the original parts it is set to shoot half length darts. On the github page of the creator you can find mods or additions for full length darts.
0
Reply
best thing I've ever printed
0
Reply
Print Profile
Revised supports + Wire Run
0
Reply
Print Profile
Revised supports + Wire Run
0
Reply
Print Profile
Revised supports + Wire Run
0
Reply
Print Profile
Revised supports + Wire Run
(Edited)
0
Reply
No more