Centering AMS Roller
Copyright Claim
Centering AMS Roller
Boost
45
83
9
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
51 min
1 plate
Boost
45
83
9
2
146
101
Released
Description
Low-profile, centering rear roller for the AMS. Allows the AMS to close when using slightly larger rolls of filament.
Prints in half. Just hold two halves together and slip on the stock bearings.
Comment & Rating (9)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
Druck funktioniert ohne Probleme, die hälften habe ich mit UHU Hart Modellkleber verklebt. Die Lager gehen sehr schwer rauf und ist etwas zu lange für d drehen nicht ordentlich
(Edited)
2
Reply
A suggestion for how to make the printing/assembly of this model better, would be to have the end parts printed separately, and inserted like pins, and have the roller cut in half at the middle, and you print the two halves standing upright, and have a 3rd pin to put the two ends together.
Edit:
I've thrown together a remix here:
https://makerworld.com/en/models/145159
(Edited)1
Reply
amazing
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
prints perfectly. I printed in petg. glued together perfectly and functioned flawlessly. just installed so I don’t know. about longevity but I am so far very happy.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
nice
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
Related Models
© 2024 MakerWorld